Posted by Ralph Bauer on September 23, 2012 at 13:41:47 from (75.107.18.96):
At auctions, they always promise to be able to assist with loading, most of the time, they do but sometimes it seems to be impossible to get the promised assistance a few days after the event, but within the promised time (of loading being furnished): I have a GN trailer with a 12k winch, triple self-cleaning ramps and wooden deck. I could drag big chunky metal items up, but do not want to get hung up, or damage the trailer floor, paint more than needed. Thought about bolting plywood to the ramps, overlay floor, or use wooden rollers or HD plastic "shoes", skids (bucket lids, cut open oil bottles) on the pulled items. Bringing my own loader means another trip (often 150 miles one way!) or getting a rental is too $. Or one loads in the middle of nowhere, snakes being more common than people... Just looking for some options that may have worked for you. Current dilemma, shop-built spray rig: booms, tank, pump& hoses already off, but rest is bulky no hubs, wheels, but repairable and needed as a whole unit. Think it weighs around 5-700 lbs. No immediate neighbors, either. Any thoughts, help, ideas are appreciated! Ralph in OK.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.