Posted by scotc on May 28, 2012 at 12:08:35 from (72.106.101.208):
In Reply to: Conversion posted by Walter Buller on May 02, 2012 at 13:24:55:
Just find any 78-93 Dodge with a good body. As long as your core support is good, the sheet metal swaps right over. I say if your core support is good, because the trucks to 90 and from 91-93 use a different core support, there is a spot where they made a little more clearance for the intercooler, and the headlights mount in a different position, I want to say higher up on the 91-93. But the body lines are the same otherwise. You can also swap over the doors and sheet metal from a pre-78, but the newer grill won't match the body lines, and they changed the grill in 91 to make room for the intercooler.
For what it's worth, the non-intercooled Cummins had bigger injectors, and often made more power than rated for. Diesel Power's "project rust bucket" in as-near-as-they-could-tell stock form, before they went into it, made 170 horse on the chassis dyno, with 20% torque converter slippage, and they were only rated 160HP. They kept all the 12-valve automatics rated for 160.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.