Posted by Phil25 on May 14, 2012 at 14:32:08 from (126.96.36.199):
In Reply to: Cummins missing. posted by Walter Buller on May 11, 2012 at 21:32:11:
not sure if this applies or not, but the air intake is clean?, if it has turbo, any chance the turbo inlet/outlet vanes are stuck/restricted? in my case there was a non-operating intake vane, setting the fault code ,and sending a stop engine signal= runs clean, but no power, sluggish,slightly, any chance that it is down on coolant? the rad level sensor will set a stop engine code also. just throwing it out there
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.