I was washing down some aluminum work we did using ZepAlum when the boss decided he wanted to smooth out a few spots. He had an air powered die grinder with a carbide burr. The wetness kept the burr from gumming up. We then ran a small stream of water on the tool and it sure cut a lot better than dry. The only drawback is we got wet, but it was a hot day. Of course don't try with electric tools. We though so highly of this discovery that the next big aluminum job we will rig a little nozzle to the tool.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.