Posted by mf294-4 on February 01, 2014 at 06:26:36 from (220.127.116.11):
In Reply to: 3 phase converter posted by teachingscience on January 31, 2014 at 10:36:46:
Ihave a 3hp lathe with a Phase-A-Matic on it. It works fine for my use. I bought a 3hp mill last year and I had a 5hp old old motor off an air compressor that I bought and put a single phase on. I bought a rotary comverter kit on Ebay for $125. Push button start. Works fine but I think the quality of the kit is a little short. If I hadn't been in a hurry, I would have scrounged up the parts myself and maybe saved some money. My mill is a variable speed and the power feed is 120v.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.