Posted by Butch(OH) on January 31, 2014 at 18:45:20 from (74.135.32.232):
In Reply to: 3 phase converter posted by teachingscience on January 31, 2014 at 10:36:46:
You said best then cheapest? which do you want? Least expensive way? Wire switched single phase 220 to any two of the three input lines on the main motor. Spin the motor in the direction you want it to run by what ever means is cheapest for you. I have seen single phase motors belted up, lawn mower recoil starters adapted and used, electric drills. I have seen rope just wrapped around the shaft. I have seen one that had the fan shroud removed and they stuck a screwdriver in the fan and spun it up. You dont have to get it up to speed just going the right direction as long as there isn't any load dragging on it. By what ever means you choose get it spinning and then throw the switch. The motor will run and you will have near 2/3 name plate HP. 3 phase for the power feeds will come from the same single phase you just attached to the main motor and the third phase will come from the un-powered third input connection for the main motor, the voltage being induced in the main motor just like the idler motor in a rotary set up.
VFDS are great where they fit but have their own set of problems too. Old motors dont like them. I found that out after ruining an old U frame 1100 RPM 10HP motor with one. Motor shop guy said something about voltage spikes and old type insulation. They also ramp up quickly in price once you get past a couple HP. I don't hate VFDs, but they are not cure-alls. You can walk your way into a rotary by building it yourself. up to 10HP converters/starters are on Ebay right now for $99, look up Phase Craft, the are made in USA. Use it to start your mill and if you decide later you need some extra power then buy an idler motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.