Restring it or just put the existing cable back on in the proper place? There is a difference.
You shouldnt have much trouble just putting the existing cable back on but you do have to be careful to make sure its in time when you are done. If the cam is not in the exact same place as before (in relation to the string) then the timing will be off. What the means is, when you draw the bow back, either the upper or lower limb will be coming back sooner, causing the arrow to go higher or lower and when you shoot, it will mess up the flight of the arrow (very inaccurate). But you can easily put it back if you are sure you can keep it in time, google a bow press and with a little thought you can make one or you can ask around if anybody you know is in an archery club, most of them own a press. The key is, to check the bow after wards to make sure its in time.
For replacing a cable its much harder because you have to get the length right, usually after removing the cable, then you have to time it. Doing that usually goes out of the DIY for most people.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.