Posted by Super-H-Mike on October 23, 2013 at 08:06:13 from (22.214.171.124):
I am putting some old corrugated tin roofing on one of my corn cribs, it is a small, low crib. I am wondering what I can do with the bottom edge, to blunt or cover the sharp edges. You see , this crib is low enough to the ground that someone could bump their head into the edges, or run their hand along it and get cut. Some sort of trim I am thinking, but need ideas. I could just bend or fold it over I suppose, but there must be a better way ? Thanks
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.