Posted by baldwin racing on October 22, 2013 at 17:06:24 from (22.214.171.124):
In Reply to: MIG welding gas posted by John D Smith on October 22, 2013 at 11:05:54:
yes straite co2 will work for welding steel....like mentioned you will have to run the co2 regulator or have your nipple changed on your regulator... where I work we would trade you tanks if in test if not in test we would charge you a test $30 and the fill. then you would have a 75/25 mix 30 what we call it....it will have great penetration but more spatter is all with straite co2
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.