Posted by Pops1532 on September 21, 2013 at 20:12:11 from (68.58.114.55):
In Reply to: Paint Shaver tool posted by Duner Wi on September 19, 2013 at 09:32:57:
I remember my Dad using something similar in the 1960's.
The modern paint shaver is much smaller and looks like it would be easier to use. Expect a rough surface when you're finished. Expect some circular gouges as well.
By all means use a vac with it.Make sure all nails are set below the surface so you don't hit them with the blades.
Is the house you want to take the paint off your house? Is it the house you live in? If the answer to either question is no, side over the existing siding with vinyl. The US EPA RRP regs will apply if it's a customer's house or if it's a rental you own, or even the house you live in if you or getting it ready to sell.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.