Ol'John T knows as much or more than I do on the topic The Reliance unit listed is a 200amp feed through transfer switch to be located outside. anywhere between the utility meter and the building service panel. The four full size or eight half size breakers are just there to be handy if power is required right at the transfer switch for portable lights, kilowat frequency meter etc. These feed through panels energize the existing building panel as if the utility service was being used. Just flip off a few breakers if a small gen set is being used. Beats having a rats nest of extension cords running through a door or window. Keeps the gen set away from the building so CO is not drifting inside. Less noise too. Also keeps all the lights on which draw very little current. Not a fan of tripping in the dark because a four circuit transfer panel is being used. The ground is never switched . There should be at least one ground rod bonded at every service,transfer panel or building entrance. As most transfer switches are set up not to switch the neutral and use a floating neutral generator. The neutral should not have any contact with ground except at the power meter/1st service panel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.