Posted by fixerupper on July 21, 2013 at 07:05:29 from (100.42.82.30):
In Reply to: Floor jack problem posted by Eric in IL on July 18, 2013 at 14:51:28:
I can't help you with the problem. I've only taken one of those type of pumps apart in my life. I have had almost no long term luck with any tool with a hand pump like that. Floor jacks, bottle jacks, port-a-powers, they all work when new but start acting like yours after a small amount of use. Day before yesterday I was using my high dollar port-a-power jacking an axle back on a truck when it suddenly acted like it was out of oil. Had plenty of oil but there was no resistance in the pump handle. I only need to go another 1/8" to get the spring clamp hole to fall in the pin but it just wouldn't go anymore. Grrr. Finally I held the pump vertically with the hose down and it started pumping again. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.