6010 doesn't need to be kept dry like 7018. In fact, it needs some moisture in the flux, so being kept in an unheated shed is all right. I'm not clear about what you're saying about the heat. 60 to 70 amps DC is pretty cool for 1/8" 6010, although you get some help with the heat when you're welding vertical up, because the heat is building up ahead of the weld more than it would in any other position. If you're saying that the work seemed overheated when you finished welding, I don't know what to tell you. You can't turn the amperage any lower than what you've got it at now. If anything, I would suggest that you turn up the amps and move faster. But metal gets hot when you weld it. If it isn't causing warping or some other problem, I'm not sure you have anything to be concerned about.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.