Before the superduty the high pinion Dana 60 front end on the F350's was fine, nothing spectacular. The Dana 50 IFS mess wasn't the best but I've never been around one personally.
The 99 and up superduties use a different Dana 50 and Dana 60 (All Dana 60 since 2002 but the outers are the same on both anyways) The newer 50/60 has some issues with seals and needle bearings due to people and even dealers thinking they are maintenance free due to the sealed unit wheel bearings but other than that they are rugged units.
The Chevy 2500HD/3500 4wd IFS up until the last couple of years, most brands of plow were too heavy and you really had to have something like a sander behind the rear axle or you exceeded your front axle weight. Even still they eat through ball joints, bushings, idlers arms and tie rods ends like crazy when wearing a plow. Friend had two landscaping companies which do snow removal in the winter with a half dozen 2500/3500's and he loves the nice ride of the chevs. Over and over the sealed ball joints went first, so in go lifetime greaseables that last a bit longer but at least have warrantee and bolts instead of rivits so they change out faster.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.