Posted by RodInNS on May 12, 2013 at 09:26:08 from (22.214.171.124):
In Reply to: welder cables posted by NEKS on May 11, 2013 at 04:31:57:
If it was mine... and it was small areas that were cracked... I'd paint over it with brush on electrical tape or tire bead sealer. It's the same product. Paint that on for a seal. Then tape over it to strengthen the remaining insulation. Then paint sealer on again to keep moisture out. If the entire cable is bad/cracked... just replace it with like cable from a welding supply store. 2/0 cable is something like 3 bucks a foot.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.