Posted by Brad Buchanan on May 10, 2013 at 06:19:26 from (22.214.171.124):
Well, we dropped the 1 1/2 hp submersible pump to 3 feet from the bottom of the 58' drilled well and jury rigged the 220v power.
We chained a 2x4 to the well casing and mounted a shop made aluminum clamp to hold the 1 1/2" plastic pipe. Mounted a 1" ball valve to control the flow and for backpressure (thanks rusted nuts).
This is a temporary setup until we mount the pitless adapter so I connected a length of so cord to the pump with the connector kit and plugged into an existing 220v receptacle in the shop.
Ran the pump at 1/4 flow for ten minutes and was pumping brown water but no detectable sand. Upped the flow to 1/2 and ran for 20 minutes and water was still cloudy but better with very little drop in water level in the well.
Upped the flow to 3/4 and filled two 55 gallon barrels in about 4 minutes. The level in the well dropped about 2 feet and there was visible turbulence in the well while pumping
Hope she clears up a bit and hope you get a kick out of the hillbilly setup.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.