Posted by GUIDO on April 21, 2013 at 14:42:11 from (71.168.252.213):
In Reply to: Re: Float Question! posted by Bob on April 21, 2013 at 13:45:09:
Hello bob, I looked at the break down of the carburetor, but that part # is for an AB. The manual for the ADH has only the carburetors listed with the models. Mine can be either an l-45B or L-48B. I'm thinking may be the l-45b-2 Stromberg model UC3/4 # 426920. The original paper manual( WHICH I DON'T HAVE) would have a service bulletin for service replacement parts for the carburetor in the back. I need to call Wisconsin Engines, and see if the can get me going. I have used the splitter after the last solder affair, and it seemed O.K. until it loads up with gas again! Thanks for your interest.........Guido.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.