Stan I used to be like you and not worry too much about it. Then about ten years ago I was helping install a Detroit diesel in where a gas engine had been. The Detroit needed two top radiator out lets. So we used a hole saw on the tank. I them needed to braze a 2 inch nipple into the tank. I did not have any black iron ones only had galvanized nipples. So I heat the galvanized nipple up and brushed the shinny zinc off of it. I then brazed the nipple into the radiator.
That night in bed I woke up unable to catch my breath. Was only able to take very shallow breaths. Passed out trying to walk down the steps. My wife called the life squad and they rushed me to the hospital. They put me on oxygen and even then my blood oxygen levels where supper low. I was in the hospital for four days. My lungs still are not as good as they where before that. The Doctor told me it was all caused by the zinc/galvanized fumes.
So I will still weld/cut galvanized metal but only with a fan and or air supply mask. Doc told me if I got another dose like that one I would be pushing dirt.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.