Posted by jon f mn on March 24, 2013 at 11:11:20 from (184.108.40.206):
In Reply to: Re: the answer posted by Chris(WA) on March 24, 2013 at 10:38:46:
I do that by continuing the crossmembers down the tail just like the deck. Then make a frame out of 1 1/4 or 1 1/2 square tube and weld a diamond plate to it. The top hinge is just a 1" shaft inside the top tube for a few inches on each side. The bottom is supported when up with a frame made out of the same tube that just tips forward underneath when its down. A couple of tabs on the support frame to keep it under the top and that's it. When up it's only for light stuff like hay and lumber and such. If you want to haul something heavy the deck needs to be down, that way there is no need for spring lifts and such.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.