Posted by John A. on March 22, 2013 at 22:59:13 from (64.128.16.238):
In Reply to: SEARS CRAFTSMAN TOOLS posted by Detmurds on March 22, 2013 at 09:08:31:
Detmurds, Next Time! get a new one off the rack FIRST. And then take it to the counter.(I always get a new on off the rack first before I go the register) I an old enough to tell the young person at the register I was buying Craftsman tools before they were Born! I get a new one!! It is MY Call Not Theirs !!!! And Do Not take any Sh!t over it. ( I remember when you brought in a ratchet wrench to get it replaced they would take it into the back and install a new ratchet mechanism) If they whip out a non-made in USA. I Do not mind being a Royal A$$ about it since I brought in a Made in USA tool, I Expect to get another one back!!! I have little to No problems getting warranty stuff when I need it. Remember it is the TOOL that is warranted, Not the original owner/purchaser! Ask them IF They are willing to loose a 20+yr customer over a $10.00 wrench. Don't Ask,, As if you are a 7 yr old in 2nd grade needing to go the restroom, TELL Them How it is! Back in the Fall I acquired a 3/4 drive Craftsman ratchet I took it to a local store in Austin, TX , mine was a USA tool, I went to get a new one off the rack and all there was was Non-USA wrenches So I took the Refurbished one! Hope this helps. Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.