As others said, the only difference is the bore size, stroke length is the same. All your bearings will fit just fine.
The head gaskets are in fact different! The 305 head gasket will stick out into the bore on a 350 and would be bad JuJu! However, you can get away with a 350 head gasket on a 305.
Should be no problem finding heads and manifolds on CL.
If you are going to ditch the TBI, you will need a different distributor. What you want is a plain jain 4 pin HEI. You only need one 10 gauge, 12V wire to make it work.
Very easy to find on any later 70's vehicle. Beware that some early 80's cars and half tons already had a basic computer and the distributor is a little different.
When shopping heads and manifolds keep in mind that Chevy changed to bolt angle on the 4 inner most holes for the intake manifold in 1987. Not a big problem but just so you don't end up with mis-matched parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.