Posted by jackinok on January 10, 2013 at 06:03:23 from (162.58.82.136):
In Reply to: Re: ramp sight posted by woodbutcher on January 10, 2013 at 04:16:53:
go down to lowes,or one of the lumber yards in your area. in the plumbing section youll find a tube of low temp silver solder that has the flux with it. position your sight and use a sharp pencil or scribe to mark the outline. clean within your mark to bare metal, then clean the bottom of sight the same. apply the paste to both pieces clamp it together and use a torch to melt the solder. i personally use a map gas torch. ive used it on some mighty hard recoiling rifles and ive not lost a sight yet,and it takes so little heat that it wont mess up your barrels blueing. its as good as anything ive used and its cheap and easy to find.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.