Looking for a mill also. Been searching for a few months. Bridgeports are the sought after stantard but there are better ones out there. I've run across a Hartford which they say is a Bridgeport clone down to parts that are interchangeable. I've been told that a Wells-Index is a very good mill and they are still in business. I've looked at Enco's. They tell me that the condition and acc is more inportant than brand. I've found some nice ones on ebsy and Craigs list but getting it here would cost more than the mill. Look on Hobby-Machinist.com They have a lot of good info.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.