he should already be deburing the ID and OD of the case neck, after resizing and triming to cut to size anyway.
meaning he needs a good caliper capable of 3 digits past thedecimal.. preferably digital or a very easy to read dial caliper.. plus he needs a grain scale.. not a gram scale AND a reload manual.. and the proper projectiles, usually with a cannelure.. and powder that matches the load data int he manual, for that weight of projectile.
I don't use nosler bal;istic tips in any of my tube laoders.. though might in my savage clip fed 340 boltgun...
I'm using win softpoints for my marlin 336 and winchesters... specifically called out for the 30-30.. not generic .308 projectiles..
these will not be carbide diese.. so case lube will be needed.
primer pocket tools too...
hard to jump into reloading without doin it with both feet. in for a penny .. in for a pound
I agree.. 25$ is cheap. must have been used.. or were lee dies.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.