Posted by rabbit on November 29, 2012 at 12:44:17 from (207.241.137.116):
In Reply to: Relaoding dies 30/30 posted by old on November 29, 2012 at 12:13:06:
Get a good reloading manual, follow it to the letter. Where they list the "DO NOT EXCEED" loads, they mean it. Wise if you stay a few grains of the recommended powder lower than that. My experience - middle of the road about halfway between "start" and "DON'T" produces the best accuracy. Have always worked loads up from the bottom of the powder recommednations - a grain or so at a time - load a few, shoot a few... Load a few somewhat heavier... 'Course, I have a chronograph available, and a range here on the farm for testing purposes.
By the way, the brand name is "Nosler", a very good manufacturer of excellent bullets. Other than what I cast myself, almost everything I load is Nosler. Except Hornady XTP in my muzzleloader.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.