Posted by NCWayne on November 29, 2012 at 11:45:34 from (69.40.232.132):
In Reply to: MIG wire feed posted by Bus Driver on November 29, 2012 at 10:23:41:
Like thew previous post said, a dirty liner can cause problems like your describing. Another thing I've found that can cause problems is a piece of weld spatter that has gotten into the contact tip. It will cause the wire to stutter past it when things get just right. Try changing the contact tip and see if that helps. Another thing is that the feed rollers may not be tight enough. Too some machines have V notched feed rollers and if they become packed with dirt, etc they will often slip and cause a stutter also. To help prevent that, if your not already doing it, try getting some of the cleaning pads for the wire that clip onto it between the spool and the feed rollers. You'd be amazed how much crap they will take off the wire. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.