1949 10 inch south bent lathe with a 36 inch bed. Still have the operator's manual with it. I've owned for 35 years, second owner. Still accurate. I don't use it a lot, but I'll never sell it. Nice to make things you can't buy. Latest project was making a brass bushing for an old cement mixer out of two brass bushings. There wasn't a large enough bushing available so I got a bushing with a 5/8 ID that would fit inside another bushing with a large enough OD for the mixer. Had to turn down the large bushing and ream out the ID of the large bushing so I could press the two together. $20 for two bushings, priceless having a lathe.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.