Posted by Lanse on October 29, 2012 at 11:33:48 from (209.251.8.126):
Hey everyone!! So...
I decided that sometime here soon I want to get some nice "C" Clamps. I have a handful of cheapies that are the 3" size, and I want to find some bigger/better ones.
I looked at all the offerings from Lowes and Home Depot, none of which really impressed me. Lowe's "BESSEY" clamps look "acceptable* to me, even tho they market them as "light duty" and they're from China. Home Depot's "HUSKY" clamps are nearly identical to the bessey's, just with a lower quality messy looking finish and the threaded rod parts were not square with the clamp in the ones I checked out last night. I suspect they're Bessey's that didnt pass quality control, but honestly, IDK.
Anyway...
I want to buy some nice 8" clamps, and maybe some 6" ones. I don't even know where to look. My school used "WILTON" clamps, but the only ones I've found sell for $50-$125 online and I think they're nice, but not nearly *that* nice.
I'd really like to find some good USA made ones. What brands/names should I be looking at? I havent found a lot. If you were looking for some nice "C" clamps, what would you look at?
Unfortunately I don't really have time to go garage saleing, I know thats usually the best option here lol. Thanks in advance...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.