Posted by RodInNS on October 21, 2012 at 12:46:55 from (184.108.40.206):
In Reply to: drill bits posted by red pocadot on October 20, 2012 at 16:44:10:
SOme decent quality HSS bits are usually about as good as you'll get for general work. I've had cheap HSS, good HSS, titanium coated, and cobalt and nearly always keep coming back to the HSS. I've got more sets (or remaining partial sets) of cheap HSS bits around here than I care to count. Cobalt is great for drilling very hard steel... but as someone else said... the slightest side load and they break. They're a lot of money for continously broken bits. Sometime you get lucky and the tips break off... but usually NOT. Just sharpen the better HSS stuff and you'll get along fine.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.