Posted by Bradracer18 on October 19, 2012 at 19:12:53 from (184.108.40.206):
In Reply to: Drill Doctor posted by Popinjohn on October 18, 2012 at 17:30:13:
We have a nice one at work, not sure on what model number, but its a big tool. My advice is to stick with the grinder, and if you can't get results, practice on some junk bits.
My next question is, do you know how to tell if you have a sharp bit for sure, and thus you have correctly sharpened it? I've seen the drill dr produce a non sharp bit many times, which probably most of the time we were too impatient with it taking 10 minutes to set up and do a good job, when it can be done on the grinder in 2 minutes or less.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.