Posted by LenND on October 16, 2012 at 18:38:01 from (220.127.116.11):
In Reply to: Hydraulic Jacks posted by Ted in Ne-OH on October 16, 2012 at 15:01:02:
Do like Fred said but instead of leaving jack set for a while just open valve and push jack down by hand or foot. What your doing is getting rid of air in the line. But your problem may be inside. There is either a single cup leather or a set of O rings on the end of the piston that are wore . So when the jack gets to the load the fluid seeps past them.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.