Posted by Rich_WI on September 28, 2012 at 20:00:31 from (184.108.40.206):
In Reply to: Concrete repair posted by Jimdril on September 28, 2012 at 15:06:17:
I have only used the vinyl patch from Menards once but I didnt care for it and dont think I would use it again. It just didnt hold up very well. You didnt say how big of a patch you need to do but most likely I would recommend Thorite. http://www.thoroproducts.com/pdf_appl/appl_thorite.pdf It works pretty good for thick patches all the way down to feather edges. It sets up quickly so you can work the patch into the profile you want or up a vertical surface. It does have a down side, its a pretty dark patch so it wont disappear when you are done but all patches can be seen afterwards.
If you have the broken piece or its a small/thin repair, just use epoxy.
Whatever you use, you might want to put in a few stainless pins to help reinforce the repair and keep it in place.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.