Posted by Dick L on September 27, 2012 at 11:10:12 from (184.108.40.206):
In Reply to: Bending Metal posted by Lucid on September 26, 2012 at 20:56:13:
I do bend up to one inch steel rounds with a propane torch with a yellow map tank in my home shop. It takes longer than the big torch at work for sure but even though it is slower it is faster than loading stuff up and driving ten miles one way, unlock, turn on lights, carry stuff back to the tool shop and then do it all backwards to get home.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.