Posted by Puddles on September 10, 2012 at 00:24:50 from (24.113.77.208):
In Reply to: Holy arc blow batman... posted by Ken Macfarlane on September 09, 2012 at 22:31:52:
I've never used a whole lot of 3/16 7018, but remember one job in the tank shop I worked in, where it was specified. Had to weld the lifting ring on this tank, the ring was 4” x 8” flatbar rolled to the outside circumference of the tank. Had to make 1 7/8” fillet weld top and bottom of this ring. Don't remember too much arc blow for the flat welding, but the overhead was an adventure!
Over the last couple years I've really noticed different brands of 6010, and 7018 like to burn off to one side. Not really arc blow, but like something is wrong with the flux. :?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.