Posted by Puddles on September 01, 2012 at 10:29:09 from (184.108.40.206):
In Reply to: Welding aluminum posted by j hikemper on August 28, 2012 at 08:07:50:
It's been quite some time since I've had to pre heat any aluminum that I want to Tig weld. My Miller Dynasty 300 doesn't even start to struggle until about 3/8-inch thick material. But I really need to get into the habit of pre heating when using my spool gun! My Lincoln Invertec V350-Pro does not have run in amps. Like some of the dedicated aluminum Mig machines, say like Miller's 350P.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.