Quoting Removed, click Modern View to seethat is precisely what it was, but not just a little, the flux was nearly half an inch longer than the metal. The total length was the same as the rest of the rods, just the metal shorter. I assume it was the tail end of a batch and the metal was slightly short, but when it went in the mold to have the flux applied it came out looking normal. It did have me puzzled for a little bit due to how much there was of it. I first just hit it a little with the grinder, and when it still would not arc just continued on with different rods till I finished what I was doing, then checked it closer.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.