Posted by john *.?-!.* cub owner on August 28, 2012 at 20:55:42 from (69.179.140.162):
I had to replace a broken hinge on the ramp for my handicap scooter carrier. I have a small wire feed welder, but it si such a piece of cheap junk that I still use my old Lincoln when possible.. I was using some 3/32 rods (6011) from K&T, and stopped to do some alignment and put in a new rod, and could not strike an arc. No spark no nothing, just as if I had a stick in the older. Could not get anything striking the rod directly on the ground clamp. Checked the welder switch, and everything else I could think of, then finally tried another rod. All was ok. Thinking it might have the coating over the endI ground it off some on the end, but still no go. Looked it over real close, and no metal showing on the end. Finally ended up grinding off nearly half an inch to get to metal.
This post was edited by john *.?-!.* cub owner at 20:57:11 08/28/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.