Thanks for the dealer suggestions, I'll look them up. I've been watching places like HGR Surplus, and a couple of the Government surplus sites, in fact I got the mill off the NC State surplus site, and have seen only one listing so far. The problem with it was that there were like 100 tool holders they put them all in two lots, which wasn't bad. The thing is each lot consisted of say 10 of one size, 5 of another, 4 of another, etc. In other words you got multiple, multiple sizes of each holder instead of the whole group being broken into multiple complete sets. If you considered the set price they went cheap enough, but as a lot I wasn't going to pay that much to have 90 extra tools I didn't need and don't have time to sell myself. Guess that was basically the same thinking they used when putting the auction together. You might get $100 less for the big lots but save $200 in time messing not having to mess with 10 lots vs 2 lots.
As far as the CAT 40 vs NST 40, best I can tell comparing them side by side, they will both fit. The only difference I can see is the CAT 40 has a metric thread for the puller bar, and the NST 40 has a standard thread.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
