Posted by Arnold Layne on October 22, 2012 at 11:43:20 from (220.127.116.11):
In Reply to: Monitor 1 1/4 HP posted by AZ Gary on October 21, 2012 at 19:01:13:
The oil level needs to be high enough that the rod dipper/slinger/cap can reach it and not much more. There is a round door on a hinge on one side of the engine, on the inside of the door is a small cup. When in service, you would fill the small cup with oil, shut the door and run one tank of fuel, then repeat. The early VJ's did not have a cylinder oiler. They about all leak oil out of the main bearings. My first hit and miss engine was a VJ.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.