Posted by patsdeere on August 27, 2012 at 23:19:06 from (18.104.22.168):
So I finally have my motor almost torn apart and down to having the carb stuck in the head. I had one person tell me that if I try and get the carb out I will either break it off flush with the head or I will strip the threads out of the head (not sure on that one). But since I have to get to the little throttle plate, since it is very stiff, any suggestions on getting it out? I have tried putting some heat on the head at the threads, but either I didn't put enough on or it is too much metal and it didn't budge. I guess the worse case scenario is I cut it off and thread the inside of the carb and the inside of the carb that is still in the head and screw it together with an adapter inside. It would restrict the flow of air, but would it restrict it to the point that it wouldn't run right? I am all ears.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.