Posted by Gary Cockerham on March 13, 2012 at 14:57:45 from (220.127.116.11):
Having trouble with my welder machine runs great welds great returns to idle normally.Have rebuilt carb,replaced points,wires,and plugs.Have ck timing good,ck fuel supply good.The problem i'm having is when you strike a arc the eng.comes up to operating rpms and starts to surge rapidly.The gov. arm bounces back and forth but you can stsbilize w/finger and welder will weld good until you start the procedure of striking a arc agsin please help desprate thanks.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.