Posted by awhtx on January 04, 2013 at 20:37:20 from (184.108.40.206):
In Reply to: rocker arm's posted by f mcclain on December 29, 2012 at 19:05:35:
I looked at some diesel tractor rocker arms and some Y-block rocker arms that I have. Both of them have 2 squirt holes- 1 for the adjusting ball to pushrod cup and another for the rocker arm to valve stem. There is an internal groove in the center of the rocker arm. The squirt hole for the adjusting ball to pushrod cup intersects this groove. The squirt hole for the rocker arm to valve stem does not intersect this groove. I hope this helps you.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.