Posted by Wascator on November 04, 2012 at 14:22:34 from (220.127.116.11):
HI, I got the 12 Volts all hooked up, gas tank on, the glass bowl is still leaking a little. I know I have ignition, but so far, all I can get is smoke out of the exhaust pipe and once, an impressive if short-lived flame from the carb air inlet (!). Perhaps I need to set the carb a little different? I have the small mixture screw 1 1/2 turns open; what about the big screw which angles up to the right? where should I set it? I did not have the engine apart: I did replace the oil pan and removed the front cover to get out some broken bolts and change the front seal.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.