Posted by greenmech on October 08, 2012 at 07:21:22 from (184.108.40.206):
In Reply to: JD A posted by ironman53 on October 07, 2012 at 21:42:10:
You will need a special flywheel wrench that fits behind the flywheel. E-bay usually had them. Or maybe a couple universal joints may work. On the block,make sure the oil line to the tappets is disconnected. Are the 4 bolts underneath out,and the ones on the side? Try a pry bar between the frame and the underside of the block to work it loose.A little PB Blaster may help. Ron Mn
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.