Posted by El Toro on October 08, 2012 at 06:32:03 from (184.108.40.206):
In Reply to: JD A posted by ironman53 on October 07, 2012 at 21:42:10:
If you have dowels on that tractor they may be the problem. If you're using a suitable hoist to lift the engine you could sway the block from side to side easily so don't break anything. You also may need to support the rear of the tractor under the drawbar to keep it from flipping backwards once the engine is pulled. You may see a slight opening at the dowels from the swaying and you can use a pinch bar or big screwdriver to move the engine off the dowels. I would use lubri-plate on the dowels when reinstalling the engine. Hal
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.