I would go a little farther by checking the air filter for debris and/or nests, clean and re-oil; pull the plugs and put a cup of atf mixed with diesel in each cylinder and let it sit for a day or two to loosen and lube the rings; then remove fluid (may have to pump it out by cranking engine); at the same time look for any water in the cylinders; while you're at it do a compression test; check radiator for any obstructions; check trans, etc for water, if found drain and replace. Check engine oil for water/anti-freeze and replace oil and filter; Check each plug, clean and regap; check all electrical connection to make sure bright and tight. That should get you going.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.