Posted by jsw2 on September 15, 2010 at 14:54:18 from (184.108.40.206):
I have a 1949 Ford 8N (front mount distributor). It ran properly two years ago and has not been used since. Two months ago, I tried to start this tractor, but it would not start. I was told that the battery needed to be replaced, so I did that a month ago. The electrical system is still 6V positive ground. Though the engine turns over when I engage the ignition, the tractor will not start.
I have followed the problem from the battery through the starter and past the generator and coil to the distributor. I have voltage getting to the distributor, but I do not have a spark at the plugs. Thus far, I have replaced the battery, coil, distributor cap, rotor button, condensor, spark plug wires, and spark plugs.
What is the next step? Links to photos showing the parts/area to test would help. Thanks!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.