I"m not a Deere man, but when I was going to school for ag mechanics one of the guys did a 466 swap into a 4430. It was ten years ago... but if my mind holds it was pretty much a bolt in deal. If the bolts are bigger in the new motor but in the same position just drill the frame rails to the right size 21/32 or 11/16. Even if the front frame rail mounting holes are a little bit off you can slot the holes with a die grinder. You will for sure have to get the air intake and filter assembly from a turbo tractor and cut a hole in the hood for the new intake system. I do not know if the cooler will clear the hood, I"m helping a guy turn a 4240 into a 4440 right now so I know the intake stuff for sure just don"t know the cooler stuff. Hope this helps a little
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
