Posted by wi50 on March 09, 2014 at 09:08:41 from (184.108.40.206):
Here's a simple tool I made up for clearancing blocks, or
checking to see what fits when useing different rod or stroke
combinations or different blocks. I just made arms with hole
centers for 1/2 stroke foe example a 6" stroke is a 3" offset, or
3" center to center on the holes. I made different slugs to fit
different main bearing bores and rod end bores of different
I don't know if it's NATPA legal to use when building a motor or
not, but it sure is handy. Maybe a few of you will make
something similar or have made something to make the job
easier. I just hate mock up, grinding, clean up, over and over. And I get way to many questions of what stroke fits with what rod in this block or that block. I can check things out ahead of time and I like to keep a greater cap angle on the rods when possiable, it makes for a bit stronger rod.
I made this tool up and send it out to people I'm working with so they can check and do a little planning for those who are building their own engines or I'm helping them with the planning, selling them parts, rotating assemblies etc.
This post was edited by wi50 at 09:15:44 03/09/14 2 times.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.