Posted by north puller on July 20, 2013 at 09:22:15 from (207.219.69.198):
In Reply to: pto dyno question posted by clampdaddy on July 19, 2013 at 12:09:11:
Some people don't get this, so i will try and explain in simple terms.
I will use a farmall example, just because i know them.
With a little bit of work, a farmall m engine could go into a 560 or viva versa.
A super m makes 47 hp at a rated engine speed of 1450 rpm. If you wind it up, it will make 53-55 hp at 1800 engine rpm.
now a 560 tractor is set up so that the engine turns 1800 rpm to get 540 pto. If you put the super m engine into the 560 tractor and put it on the dyno, the engine would turn faster (1800) to get a 540 pto speed, and you would read 53 hp on the dyno.
Put that engine back into the super m tractor and put it on the dyno, and it would turn 1450 to give you 540 pto and read 47 hp on the dyno.
You are basically doing the same thing. You are changing the engine rpm in relation to the pto rpm.since in the tractor world hp is measured based on pto rpm, changing the engine input speed will give you a different hp reading.
If you were to use a pony brake belt pulley dyno, you would see no difference on your John Deere because the pulley speed doesn't change with the gearing change.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.